Cloud29 · Guide
How to add Ubiquiti devices to your hosted UISP Controller at customer.cloud29.cloud.
Cloud29 · UISP Controller Setup
The UISP Application supports all UISP-branded devices as well as a wide range of Ubiquiti ISP hardware:
- airMAX, airFiber, UISP Wave
- LTU, UFiber, EdgeRouter
- UISP Console, UISP Router, UISP Switch
- Power on the device and wait for it to fully boot (around 60 seconds).
- Install the UISP Mobile App from the App Store or Google Play.
- Enable Bluetooth on your phone and open the UISP App.
- Use the app to detect and adopt your device to your UISP Controller:
customer.cloud29.cloud.
Bluetooth adoption is supported by UISP routers, switches, and Consoles. Wireless radios broadcast a management SSID when unadopted.
- Connect the device to an Internet-enabled network and power it on.
- Determine the device IP via DHCP leases or fallback address (e.g.
192.168.1.20).
- Access the device's Web UI and log in with the default or assigned credentials.
- Upgrade to the latest firmware if prompted.
- Navigate to the UISP section and input your UISP key from the UISP Controller to adopt the device.
- Ensure the device is in its factory default state and connected to the Internet.
- Log in to your UISP Controller at
customer.cloud29.cloud.
- Go to the Devices section and locate devices marked as Pending Adoption.
- Select the device and click Adopt.
- Devices must be on supported firmware versions and in factory default state to be eligible for adoption.
- The UISP Mobile App is required for Bluetooth pairing and setup flows.
- Some devices may require a manual firmware update before showing up in UISP.
- Always adopt devices into the correct site or organization context in UISP.